When choosing the location of the terminal, care should be taken to select an area with consistent light levels throughout the day and avoid areas where the unit may be subjected to direct bright sunlight.
Using the enclosed installation diagram, drill three holes in the wall with the lower hole 1150mm from the floor.
If using the optional housing, pass the mounting screws through the metal back plate and then through the matching holes in the housing and tighten the screws.
Connect the power adapter to the socket on the rear of the terminal.
Hang the terminal on the back plate and secure with the single fixing screw on the base.
Fit the lens cover insert and housing front if installing in the optional protective case.
Standby Status
After powering up the terminal, the terminal will enter its standby mode (after approx 30 seconds).
The terminal will display will look like the following:
Fig 1
If the terminal detects someone in front of it, it will enter the detecting mode and the display will show:
Fig 2
